Describe It36CleanupAfterTest Shutdown the system. here. ---+ Close down the test

This page describes how to close down the test, when the test is completed

*DO NOT USE THIS STEP UNLESS YOU ARE DONE AND READY TO CLEAN UP*

---++ Do the following on kb-prod-udv-001.kb.dk as a test user:

If you are not sure of the value of $TESTX then make sure that it is set to <verbatim> export TESTX=TESTk (where k must be replaced with the test number you are about finish) export PORT=8076 (where 8076 with the given port number for the test) export MAILRECEIVERS=tlr@kb.dk (where the mail address must be replaced by address(es) for the relevant mail receiver(s) – specified by comma separation if more than one) </verbatim>

Run following (as written)

<verbatim> cleanup_all_test.sh </verbatim>

This =cleanup= script handles all three install scenarios (single, classical, and multi-bitapps).

-- Main.jolf - 19 Mar 2009