Perform a installation with a checksum replica

Do the following on kb-prod-udv-001.kb.dk as a test user:

If you are not sure of the value of $TESTX then make sure that it is set to

export TESTX=TESTk              (where k must be replaced with the test number you are about finish)
export PORT=8076                (where 8076 with the given port number for the test)
export MAILRECEIVERS=tlr@kb.dk  (where the mail address must be replaced by address(es) for the relevant mail receiver(s) – specified by comma separation if more than one)

Run following (as written)

prepare_test_checksum.sh
install_test.sh

It42InstallWithChecksumReplica (last edited 2010-08-16 10:24:35 by localhost)