1152
Comment:
|
1169
|
Deletions are marked like this. | Additions are marked like this. |
Line 1: | Line 1: |
Install/reinstall release package and start the system This page describes how to | Install/reinstall release package and start the system |
Line 3: | Line 3: |
Optionally close an earlier instance of the system Install a new instance Start the new instance This includes stopping existing old applications, emptying the JMS queues and move old data into a backup catalogs. Both bit-archive libraries and other old data are cleaned up. A pure and clean new installation is established. Note: If there no tests have been executed on this port number before, then there might appear error messages about non-existing files etc. These errors are harmless. | This page describes how to * Optionally close an earlier instance of the system * Install a new instance * Start the new instance.This includes stopping existing old applications, emptying the JMS queues and move old data into a backup catalogs. Both bit-archive libraries and other old data are cleaned up. A pure and clean new installation is established. Note: If there no tests have been executed on this port number before, then there might appear error messages about non-existing files etc. These errors are harmless. |
Install/reinstall release package and start the system
This page describes how to
- Optionally close an earlier instance of the system
- Install a new instance
- Start the new instance.This includes stopping existing old applications, emptying the JMS queues and move old data into a backup catalogs. Both bit-archive libraries and other old data are cleaned up. A pure and clean new installation is established.
Note: If there no tests have been executed on this port number before, then there might appear error messages about non-existing files etc. These errors are harmless.
Do the following on kb-prod-udv-001.kb.dk as a test user: Write the following in a prompt – note the relevant replacements
export TESTX=TESTk (where k must be replaced with the test number you are about to run, e.g. TEST8)
export PORT=8076 (where 8076 with the given port number for the test)
export MAILRECEIVERS= tlr@kb.dk (where the mail address must be replaced by address(es) for the relevant mail receiver(s) – specified by comma separation if more than one)
cleanup_all_test.sh
prepare_test_dedup_disabled.sh
install_test.sh
start_test.sh